Feature
GENERAL DESCRIPTION
The ICM-20600 is a 6-axis MotionTracking device that combines a 3-axis gyroscope, 3-axis accelerometer, in a small 2.5 mm x 3 mm x 0.91 mm (14-pin LGA) package.
High performance specs
o Gyroscope sensitivity error: ±1%
o Gyroscope noise: ±4 mdps/Hz
o Accelerometer noise: 100 µg/Hz
Includes 1 KB FIFO to reduce traffic on the serial bus interface, and reduce power consumption
by allowing the system processor to burst read sensor data and then go into a low-power mode
EIS FSYNC support ICM-20600 includes on-chip 16-bit ADCs, programmable digital filters, an embedded temperature sensor, and programmable interrupts. The device features an operating voltage range down to 1.71V.
Communication ports include I²C and high speed SPI at 10 MHz.
APPLICATIONS
Smartphones and Tablets
Wearable Sensors
IoT Applications
Motion-based game controllers
3D remote controls for Internet connected DTVs and set top boxes, 3D mice
FEATURES
3-Axis Gyroscope with Programmable FSR of ±250 dps, ±500 dps, ±1000 dps, and ±2000 dps
3-Axis Accelerometer with Programmable FSR of ±2g,±4g, ±8g, and ±16g
User-programmable interrupts
Wake-on-motion interrupt for low power operation of applications processor
1 KB FIFO buffer enables the applications processor to read the data in bursts
On-Chip 16-bit ADCs and Programmable Filters
Host interface: 10 MHz SPI or 400 kHz Fast Mode I2C
Digital-output temperature sensor
VDD operating range of 1.71 to 3.45V
MEMS structure hermetically sealed and bonded at wafer level
RoHS and Green compliant
Applications
(Picture:Pinout / Diagram)
