Micron� 25nm MLC NAND Flash RoHS-compliant package SATA 6 Gb/s interface ATA modes supported � PIO mode 4 � Multiword DMA mode Ultra DMA mode Industry-standard, 512-byte sector size support Native command queuing support with 32-command slot support ATA-8 ACS2 command set compliant ATA security feature command set and password login support Secure erase (data page) command set: fast and secure erase Self-monitoring, analysis, and reporting technology (SMART) command set 2 � Sequential 128k READ: to 500 MB/s � Sequential 128k WRITE: to 260 MB/s � Random 4k READ: to 45,000 IOPS � Random 4k WRITE: to 50,000 IOPS � PCMark� Vantage (HDD test suite score): 75,000 � READ/WRITE latency: 55�s (TYP) Reliability � MTTF: 1.2 million device hours3 � Static and dynamic wear leveling � Uncorrectable bit error rate (UBER): <1 sector per 1015 bits read Low power consumption � <200mW TYP 4 Endurance: Total bytes written (TBW) 72TB Capacity5 (unformatted): 128GB, 256GB Mechanical � 5mm height � mSATA connector: �5% � Caseless design: 3.75mm � Weight: 10g (MAX) Field-updateable firmware Operating temperature � Commercial to +70�C)6
Notes: 1. Typical I/O performance numbers as measured using Iometer with a queue depth of 32 and write cache enabled. 2. 4K transfers used for READ/WRITE latency values. 3. The product achieves a mean time to failure (MTTF) based on population statistics not relevant to individual units. 4. Active power measured during execution of MobileMark� 2007 with DIPM (device-initiated power management) enabled. = 1 billion bytes; formatted capacity is less. 6. Drive case temperature.
Warranty: Contact your Micron sales representative for further information regarding the product, including product warranties.
Products and specifications discussed herein are subject to change by Micron without notice.Micron Technology, Inc. reserves the right to change products or specifications without notice. � 2011 Micron Technology, Inc. All rights reserved.
C400 mSATA NAND Flash SSD Features Part Numbering InformationMicron's RealSSDTM C400 SSD is available in different configurations and densities. Visit www.micron.com for a list of valid part numbers. Figure 1: Part Number Chart
D = SATA 6.0 Gb/s Hardware Feature Set Blank = Commercial to +70�C)Blank = Null AA = Contact factory AB = Contact factory AC = Contact factory
Blank = Null 1 = Contact factory 2 = Contact factory
Micron's RealSSD solid state drive (SSD) uses a single-chip controller with a SATA interface on the system side and n-channels of Micron NAND Flash internally. Packaged in an JEDEC-standard mSATA form factor, the SSD integrates easily in existing storage infrastructures. The SSD is designed to use the SATA interface efficiently during both READs and WRITEs while delivering bandwidth-focused performance. SSD technology enables enhanced boot times, faster application load times, reduced power consumption, and extended reliability. Figure 2: Functional Block Diagram
