All trademarks are the property of their respective owners.
DescriptionThis 8-bit non-inverting translator uses two separate configurable power-supply rails.The A port tracks the VCCA pin supply voltage. TheVCCA pin accepts any supply voltage between 1.4 V and 3.6 V. The B port tracks theVCCB pin supply voltage. The VCCB pin accepts anysupply voltage between 1.65 V and 5.5 V. Two input supply pins allows for low Voltage bidirectionaltranslation between any of the 1.5V, 1.8 V, 2.5 V, 3.3 V, and 5 V voltage nodes.
When the output-enable (OE) input is low, all outputs are placed in the high-impedance(Hi-Z) state.
To ensure the Hi-Z state during power-up or power-down periods, tie OE to GND through apull-down resistor. The minimum value of the resistor is determined by the current-sourcingcapability of the driver.
Feature
- AEC-Q100 Qualified for Automotive Applications
- Device Temperature Grade 1: –40°C to 125°C
- Device HBM ESD Classification Level 2
- Device CDM ESDClassification Level C6
- No Direction-Control Signal Needed
- Maximum Data Rates
- 110 Mbps (Push Pull)
- 1.2 Mbps (Open Drain)
- 1.4 V to 3.6 V onA Port and 1.65 V to 5.5 V on B Port (VCCA≤VCCB)
- No Power-Supply Sequencing Required – Either VCCA orVCCB Can Be Ramped First
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- ESD Protection Exceeds JESD 22 (A Port)
- 2000 V Human Body Model (A114-B)
- 1000 V Charged-Device Model (C101)
- IEC 61000-4-2 ESD (B Port)
- ±8 kV Contact Discharge
- ±6 kV Air-Gap Discharge
All trademarks are the property of their respective owners.
DescriptionThis 8-bit non-inverting translator uses two separate configurable power-supply rails.The A port tracks the VCCA pin supply voltage. TheVCCA pin accepts any supply voltage between 1.4 V and 3.6 V. The B port tracks theVCCB pin supply voltage. The VCCB pin accepts anysupply voltage between 1.65 V and 5.5 V. Two input supply pins allows for low Voltage bidirectionaltranslation between any of the 1.5V, 1.8 V, 2.5 V, 3.3 V, and 5 V voltage nodes.
When the output-enable (OE) input is low, all outputs are placed in the high-impedance(Hi-Z) state.
To ensure the Hi-Z state during power-up or power-down periods, tie OE to GND through apull-down resistor. The minimum value of the resistor is determined by the current-sourcingcapability of the driver.
